tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/27 14:20] pereira [Setting up Reaction Settings] |
tuning_the_s800_xdt [2015/10/27 14:26] pereira [CRDCs setup] |
||
|---|---|---|---|
| Line 155: | Line 155: | ||
| * They correspond to the non-dispersive position of the beam in the CRDCs. | * They correspond to the non-dispersive position of the beam in the CRDCs. | ||
| - | {{: | + | {{: |
| Line 310: | Line 310: | ||
| * Reaction setting to FP | * Reaction setting to FP | ||
| * Start with Attenuator setting of unreacted beam and step up in intensity | * Start with Attenuator setting of unreacted beam and step up in intensity | ||
| - | * Set up beam blocker (labeled I255 Slits) in the S3 page of Barney, if necessary | + | * Looking at **CRDC1.RAWS** and/or **CRDC2.RAWS** SpecTcl spectra (shown in **S800_CRDCS.WIN**), |
| * Expected " | * Expected " | ||
| * Expect to see unreacted beam if reaction setting is within +/- 3% of unreacted beam setting | * Expect to see unreacted beam if reaction setting is within +/- 3% of unreacted beam setting | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
