tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/27 16:43] pereira [Ionization Chamber setup] |
tuning_the_s800_xdt [2015/10/29 09:57] pereira [Checking Particle ID and rate at S800 FP] |
||
|---|---|---|---|
| Line 127: | Line 127: | ||
| * Count rate is a little higher than on scintillator due to noise or thresholds | * Count rate is a little higher than on scintillator due to noise or thresholds | ||
| - | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** (see figure below) to verify the good performance of the detectors. (The spectra for each CRDC can be checked separatelly in windows **s800_CRDC1.win** and **S800_CRDC2.win**) | + | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** in directory **/ |
| * Spectra **crdc1.raws** and **crdc2.raws** (top and middle spectra in the leftmost (first) column) | * Spectra **crdc1.raws** and **crdc2.raws** (top and middle spectra in the leftmost (first) column) | ||
| Line 187: | Line 187: | ||
| * Select SpecTcl window **S800_PID.win** in directory **/ | * Select SpecTcl window **S800_PID.win** in directory **/ | ||
| * The three columns correspond to the PID determined with the **RF-FP** ToF (left), **OBJ-FP** (center), and **XFP-FP** (right) | * The three columns correspond to the PID determined with the **RF-FP** ToF (left), **OBJ-FP** (center), and **XFP-FP** (right) | ||
| - | * The first (top) row corresponds to the Phillips TDC | + | * The first (top) row corresponds to PID spectra using the Phillips TDC |
| - | * The second row corresponds to the MTDC with just the first hit included | + | * The second row corresponds to PID spectra using the MTDC with __just |
| - | * The third row corresponds to the ORTEC TACs. Note that there is not **RF-FP TAC** | + | * The third row corresponds to PID spectra using the MTDC gated on the " |
| + | * The fourth row corresponds to PID spectra using the ORTEC TACs. Note that there is not **RF-FP TAC** | ||
| * You might need to adjust the limits of the spectra to get a good resolution | * You might need to adjust the limits of the spectra to get a good resolution | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
