tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/29 09:57] pereira [Checking Particle ID and rate at S800 FP] |
tuning_the_s800_xdt [2015/10/29 10:01] pereira [Timing setup] |
||
|---|---|---|---|
| Line 166: | Line 166: | ||
| * The three columns correspond to the **RF-FP** ToF (left), **OBJ-FP** (center), and **XFP-FP** (right) | * The three columns correspond to the **RF-FP** ToF (left), **OBJ-FP** (center), and **XFP-FP** (right) | ||
| * The first (top) row corresponds to the Phillips TDC | * The first (top) row corresponds to the Phillips TDC | ||
| - | * The second row corresponds to the MTDC with all the hits included | + | * The second row corresponds to the MTDC with all the hits included. Note that in a unreacted-beam setting, the first hit typically provides the " |
| * The third row corresponds to the MTDC with only the first hit | * The third row corresponds to the MTDC with only the first hit | ||
| * The fourth row corresponds to the ORTEC TACs. Note that there is not **RF-FP TAC** | * The fourth row corresponds to the ORTEC TACs. Note that there is not **RF-FP TAC** | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
