tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/29 13:21] pereira [Checking Particle ID and rate at S800 FP] |
tuning_the_s800_xdt [2015/10/29 13:23] pereira [Timing setup] |
||
|---|---|---|---|
| Line 177: | Line 177: | ||
| * Due to the multi-hit capability of the MTDC, we need to select the " | * Due to the multi-hit capability of the MTDC, we need to select the " | ||
| * Use the spectra **TOF.MTDC_RF**, | * Use the spectra **TOF.MTDC_RF**, | ||
| - | * Using the cursor mouse, check the lower and higher limits defining the region in the MTDC ToF spectra with the " | + | * Using the cursor mouse, check the lower and higher limits defining the region in the MTDC ToF spectra with the " |
| * Go to the **Variables** page in SpecTcl GUI and assign the limits to the following variables: | * Go to the **Variables** page in SpecTcl GUI and assign the limits to the following variables: | ||
| - | * s800.fp.vmetdc.mtdc_objlow and s800.fp.vmetdc.mtdc_rfhigh for RF-XFP | + | |
| - | * s800.fp.vmetdc.mtdc_objlow and s800.fp.vmetdc.mtdc_rfhigh for OBJ-XFP | + | |
| - | * s800.fp.vmetdc.mtdc_xfplow and s800.fp.vmetdc.mtdc_xfphigh for XFP-XFP | + | |
| * For each ToF, SpecTcl will search the hit number that fits in the selected region. The new MTDC ToF parameters are **s800.fp.vmetdc.mtdc_rf**, | * For each ToF, SpecTcl will search the hit number that fits in the selected region. The new MTDC ToF parameters are **s800.fp.vmetdc.mtdc_rf**, | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
