tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2017/05/26 16:06] pereira [Timing setup] |
tuning_the_s800_xdt [2017/05/26 16:08] pereira [Timing setup] |
||
|---|---|---|---|
| Line 189: | Line 189: | ||
| * Adjust the TDC delays of OBJ and/or XFP with respect to the TDC start, using the delay boxes connected to the CANBERRA CFD 454 in data U6 | * Adjust the TDC delays of OBJ and/or XFP with respect to the TDC start, using the delay boxes connected to the CANBERRA CFD 454 in data U6 | ||
| * Be aware that the after adjusting OBJ and XFP delays in the scope, the signal will be further delayed by ~200 ns due to the length of the cable between dataU6 patch panel and the Phillips TDC in the S3 vault. | * Be aware that the after adjusting OBJ and XFP delays in the scope, the signal will be further delayed by ~200 ns due to the length of the cable between dataU6 patch panel and the Phillips TDC in the S3 vault. | ||
| + | * Check the corresponding ToF spectra in SpecTcl to confirm that the timings are properly adjusted. | ||
| * Check the efficiencies of the Phillips TDC, TACs, and MTDC for the OBJ-FP and XFP-FP ToFs: | * Check the efficiencies of the Phillips TDC, TACs, and MTDC for the OBJ-FP and XFP-FP ToFs: | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
