This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
tuning_the_s800_xdt [2017/05/26 21:54] pereira [CRDCs setup] |
tuning_the_s800_xdt [2017/05/26 21:56] pereira [CRDCs setup] |
||
---|---|---|---|
Line 161: | Line 161: | ||
* Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS_EFF.win** (see figure below) to verify the efficiency of the detectors. | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS_EFF.win** (see figure below) to verify the efficiency of the detectors. | ||
- | | + | |
- | * Make a gate in spectrum **ic.sum** (top right plot) to select the Z region of interest, and call it **ic** | + | * Make a gate in spectrum **ic.sum** (top right plot) to select the Z region of interest, and call it **ic** |
- | * Make a summing region around the " | + | * Make a summing region around the " |
- | * Stop the run and rescan data from disk | + | * Stop the run and rescan data from disk |
- | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) | + | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) |
- | {{: | + | {{: |
==== Timing setup ==== | ==== Timing setup ==== |