This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
tuning_the_s800_xdt [2017/05/26 21:54] pereira [CRDCs setup] |
tuning_the_s800_xdt [2017/06/17 14:37] pereira [FP scintillator setup] |
||
---|---|---|---|
Line 66: | Line 66: | ||
==== FP scintillator setup ==== | ==== FP scintillator setup ==== | ||
+ | |||
+ | * Make sure that S800 DAQ is in [[s800 daq tools# | ||
* Set trigger to “s800 trigger” | * Set trigger to “s800 trigger” | ||
Line 159: | Line 161: | ||
- | | + | |
- | + | | |
- | | + | |
- | * Make a gate in spectrum **ic.sum** (top right plot) to select the Z region of interest, and call it **ic** | + | |
- | * Make a summing region around the " | + | |
- | * Stop the run and rescan data from disk | + | |
- | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) | + | |
- | {{: | + | {{: |
==== Timing setup ==== | ==== Timing setup ==== |