tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2017/05/26 21:56] pereira [CRDCs setup] |
tuning_the_s800_xdt [2017/05/26 21:58] pereira [CRDCs setup] |
||
|---|---|---|---|
| Line 159: | Line 159: | ||
| - | | + | |
| + | * Start a new run recording data on disk | ||
| + | * Make a gate in spectrum **ic.sum** (top right plot) to select the Z region of interest, and call it **ic** | ||
| + | * Make a summing region around the " | ||
| + | * Stop the run and rescan data from disk | ||
| + | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) | ||
| - | * Start a new run recording data on disk | + | {{: |
| - | * Make a gate in spectrum **ic.sum** (top right plot) to select the Z region of interest, and call it **ic** | + | |
| - | * Make a summing region around the " | + | |
| - | * Stop the run and rescan data from disk | + | |
| - | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) | + | |
| - | + | ||
| - | {{: | + | |
| ==== Timing setup ==== | ==== Timing setup ==== | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
