tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2017/05/26 21:58] pereira [CRDCs setup] |
tuning_the_s800_xdt [2017/06/17 14:37] pereira [FP scintillator setup] |
||
|---|---|---|---|
| Line 66: | Line 66: | ||
| ==== FP scintillator setup ==== | ==== FP scintillator setup ==== | ||
| + | |||
| + | * Make sure that S800 DAQ is in [[s800 daq tools# | ||
| * Set trigger to “s800 trigger” | * Set trigger to “s800 trigger” | ||
| Line 166: | Line 168: | ||
| * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) | ||
| - | {{: | + | {{: |
| ==== Timing setup ==== | ==== Timing setup ==== | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
