This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
tuning_the_s800_xdt [2017/06/17 15:06] pereira [Coincidences] |
tuning_the_s800_xdt [2017/06/17 15:10] pereira [Coincidences] |
||
---|---|---|---|
Line 374: | Line 374: | ||
* Setup | * Setup | ||
- | * Coincidence signals are usually visible on scope without running scope in acquire mode | + | * Using the [[S800 DAQ tools# |
+ | * Assign each wire to an inspect channel from the patch panel so that you can check their timings | ||
* Adjust the width of the early signal (S800 or secondary) should be wide enough to catch coincidences with the late signal (width of late signal is not critical) | * Adjust the width of the early signal (S800 or secondary) should be wide enough to catch coincidences with the late signal (width of late signal is not critical) | ||
* Readjust TDC delays based on changes made to S800 trigger delay | * Readjust TDC delays based on changes made to S800 trigger delay |