tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2017/06/17 15:06] pereira [Coincidences] |
tuning_the_s800_xdt [2017/06/17 15:12] pereira [Coincidences] |
||
|---|---|---|---|
| Line 374: | Line 374: | ||
| * Setup | * Setup | ||
| - | * Coincidence signals are usually visible on scope without running scope in acquire mode | + | * Using the [[S800 DAQ tools# |
| + | * Assign each wire to an inspect channel from the patch panel so that you can check their timings | ||
| * Adjust the width of the early signal (S800 or secondary) should be wide enough to catch coincidences with the late signal (width of late signal is not critical) | * Adjust the width of the early signal (S800 or secondary) should be wide enough to catch coincidences with the late signal (width of late signal is not critical) | ||
| * Readjust TDC delays based on changes made to S800 trigger delay | * Readjust TDC delays based on changes made to S800 trigger delay | ||
| Line 383: | Line 384: | ||
| * This check is required for verification in cases of low beam intensity (e.g. 1000 pps) | * This check is required for verification in cases of low beam intensity (e.g. 1000 pps) | ||
| * Length of run required is typically about 10-15 minutes | * Length of run required is typically about 10-15 minutes | ||
| - | * To be resolved: | + | |
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
