tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2017/06/17 15:10] pereira [Coincidences] |
tuning_the_s800_xdt [2017/06/17 15:10] pereira [Coincidences] |
||
|---|---|---|---|
| Line 374: | Line 374: | ||
| * Setup | * Setup | ||
| - | * Using the [[S800 DAQ tools# | + | * Using the [[S800 DAQ tools# |
| * Assign each wire to an inspect channel from the patch panel so that you can check their timings in the oscilloscope | * Assign each wire to an inspect channel from the patch panel so that you can check their timings in the oscilloscope | ||
| * Adjust the width of the early signal (S800 or secondary) should be wide enough to catch coincidences with the late signal (width of late signal is not critical) | * Adjust the width of the early signal (S800 or secondary) should be wide enough to catch coincidences with the late signal (width of late signal is not critical) | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
