tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2023/08/18 18:01] pereira [CRDCs setup] |
tuning_the_s800_xdt [2023/09/22 14:50] swartzj [CRDCs setup] |
||
|---|---|---|---|
| Line 44: | Line 44: | ||
| * Use oscilloscope to look at analog signal patched out to data U4 | * Use oscilloscope to look at analog signal patched out to data U4 | ||
| - | * Check raising | + | * Check rise time and amplitude. Good signal: ~10 ns rise time; 400-500 mV amplitude |
| * Check if there are reflections (typically seen at ~300 ns after main peak) | * Check if there are reflections (typically seen at ~300 ns after main peak) | ||
| Line 91: | Line 91: | ||
| * Adjust biases so that unreacted beam are at 1/3 to 1/4 of dynamic range | * Adjust biases so that unreacted beam are at 1/3 to 1/4 of dynamic range | ||
| * Reaction product will typically be similar enough to unreacted beam particles | * Reaction product will typically be similar enough to unreacted beam particles | ||
| - | * Different particles with different energy | + | * Different particles with different energy |
| | | ||
| {{: | {{: | ||
| Line 123: | Line 123: | ||
| * **[[hv bias#hv remote control|Bias]]** CRDCs | * **[[hv bias#hv remote control|Bias]]** CRDCs | ||
| * Look at anode signal on **[[electronics overview|scope]]** | * Look at anode signal on **[[electronics overview|scope]]** | ||
| - | * Patched to data-U6 on labeled connector | + | * Patched to data-U4 on labeled connector |
| * **200 – 500 mV** signals are good | * **200 – 500 mV** signals are good | ||
| * CRDC1 anode is noisier (digital noise) than CRDC2 | * CRDC1 anode is noisier (digital noise) than CRDC2 | ||
| Line 140: | Line 140: | ||
| * Spectra **crdc1.raws** and **crdc2.raws** | * Spectra **crdc1.raws** and **crdc2.raws** | ||
| - | * Each spectra | + | * Each spectrum |
| * The 224 pads are assembled along the dispersive direction | * The 224 pads are assembled along the dispersive direction | ||
| * Width of beam peak is proportional to A1900 p-acceptance in focus optics | * Width of beam peak is proportional to A1900 p-acceptance in focus optics | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
