User Tools

Site Tools


tuning_the_s800_xdt

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
tuning_the_s800_xdt [2023/09/22 14:36]
swartzj [Object scintillator setup]
tuning_the_s800_xdt [2023/09/22 14:51]
swartzj [CRDCs setup]
Line 91: Line 91:
             * Adjust biases so that unreacted beam are at 1/3 to 1/4 of dynamic range             * Adjust biases so that unreacted beam are at 1/3 to 1/4 of dynamic range
             * Reaction product will typically be similar enough to unreacted beam particles             * Reaction product will typically be similar enough to unreacted beam particles
-        * Different particles with different energy loss will shift the curve corresponding to particles covering whole FP+        * Different particles with different energy losses will shift the curve corresponding to particles covering whole FP
                                          
             {{:wiki:E1-updown.png?500|S800 spectra E1 down vs. E1 up.}}             {{:wiki:E1-updown.png?500|S800 spectra E1 down vs. E1 up.}}
Line 123: Line 123:
   * **[[hv bias#hv remote control|Bias]]** CRDCs   * **[[hv bias#hv remote control|Bias]]** CRDCs
       * Look at anode signal on **[[electronics overview|scope]]**  while biasing drift and anode       * Look at anode signal on **[[electronics overview|scope]]**  while biasing drift and anode
-          * Patched to data-U6 on labeled connector+          * Patched to data-U4 on labeled connector
           * **200 – 500 mV** signals are good           * **200 – 500 mV** signals are good
           * CRDC1 anode is noisier (digital noise) than CRDC2            * CRDC1 anode is noisier (digital noise) than CRDC2 
Line 137: Line 137:
       * Count rate is a little higher than on scintillator due to noise or thresholds       * Count rate is a little higher than on scintillator due to noise or thresholds
  
-  * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** (see figure below), or, alternatively **S800_MEGASUMMARY.win** to verify the good performance of the detectors. (The spectra for each CRDC can be checked separatelly in windows **s800_CRDC1.win** and **S800_CRDC2.win**)+  * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** (see figure below), or, alternatively **S800_MEGASUMMARY.win** to verify the good performance of the detectors. (The spectra for each CRDC can be checked separately in windows **s800_CRDC1.win** and **S800_CRDC2.win**)
  
       * Spectra **crdc1.raws** and **crdc2.raws**        * Spectra **crdc1.raws** and **crdc2.raws** 
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj