This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
turning_magnets_on_off [2015/10/19 13:43] pereira [Turn on S800 magnets power supply] |
turning_magnets_on_off [2015/10/19 14:46] pereira [Set S800 magnets settings] |
||
---|---|---|---|
Line 37: | Line 37: | ||
{{: | {{: | ||
- | * The magnet currents corresponding to a given setting are typically set using [[Turning magnets on/off#set S800 magnets settings|Barney]]. However, it is also possible to set them individually for an specific magnet, as explained [[Turning magnets on/off#Set currents individually|here]]. | + | * The magnet currents corresponding to a given setting are typically set using [[Turning magnets on/off#set S800 magnets settings|Barney]]. However, it is also possible to set them individually for an specific magnet, as explained [[Turning magnets on/ |
Line 60: | Line 59: | ||
* Ensure that the current in the dipoles are properly matched to the desired values (see section on [[NMR probes# | * Ensure that the current in the dipoles are properly matched to the desired values (see section on [[NMR probes# | ||
+ | |||
+ | * Note: The currents in the Trim coils will be set automatically in Barney, once the rigidity in Segment 8 was entered. | ||
===== Set magnet currents individually ===== | ===== Set magnet currents individually ===== | ||
- | **NOTE: | + | The values of currents for the different magnets can be modified individually by clicking the button " |
| | ||
+ | {{: | ||