Differences

This shows you the differences between two versions of the page.

--- turning_magnets_on_off [2015/10/19 13:50]
pereira [Set magnet currents individually]
+++ turning_magnets_on_off [2015/10/19 14:46]
pereira [Set S800 magnets settings]
@@ Line 59: / Line 59: @@
       * Ensure that the current in the dipoles are properly matched to the desired values (see section on [[NMR probes#Matching|NMR control]])
+      * Note: The currents in the Trim coils will be set automatically in Barney, once the rigidity in Segment 8 was entered.
 ===== Set magnet currents individually =====
-**NOTE:** The values of currents for the different magnets can be modified individually by clicking the button "details" in the Barney page (see upper-right corner in figure above). A list of magnets with their corresponding currents will be displayed as shown in the figure below. To change the current of a given magnet, just click in the magnet and type the desire value.
+The values of currents for the different magnets can be modified individually by clicking the button "details" in the Barney page (see upper-right corner in figure above). A list of magnets with their corresponding currents will be displayed as shown in the figure below. To change the current of a given magnet (e.g. I265DS), go to column **Read Amps** and click in the "cell" corresponding to the magnet (see red circle in figure below). A new window will pop-out; enter the new value of the current (e.g. 10 A) and click "Apply".
+{{:wiki:barneys800details.jpg?750|Barney S800 "details" page.}}

S800 Documentation

User Tools

Site Tools

Differences

Page Tools