vacuum_control
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
vacuum_control [2016/11/09 14:57] pereira [Target Chamber] |
vacuum_control [2016/11/09 15:27] pereira [Venting analysis-line lower-dipole section] |
||
|---|---|---|---|
| Line 51: | Line 51: | ||
| - Verify that the target area is vented. | - Verify that the target area is vented. | ||
| - | - Ensure | + | - Using the EMIS controllers in the middle level of the S3 vault (see figure above), ensure |
| - Ensure that gate valves I246GV (between lower-dipole section and target area) and I215GV (between intermediate image area and the lower-dipole section) are closed. | - Ensure that gate valves I246GV (between lower-dipole section and target area) and I215GV (between intermediate image area and the lower-dipole section) are closed. | ||
| - Open S800vac with PanelMate. | - Open S800vac with PanelMate. | ||
| Line 62: | Line 62: | ||
| + | {{: | ||
| + | |||
| + | |||
| + | {{: | ||
| ===== Spectrograph ===== | ===== Spectrograph ===== | ||
| This system is pumped with cryopumps. Please do not vent this section if the target chamber is under vacuum pressure. The pressure gradient between both sections would " | This system is pumped with cryopumps. Please do not vent this section if the target chamber is under vacuum pressure. The pressure gradient between both sections would " | ||
vacuum_control.txt ยท Last modified: 2019/10/17 10:43 by pereira
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
