venting_pumping_intermediate_image_box
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
venting_pumping_intermediate_image_box [2018/12/19 11:07] pereira [Venting/pumping Intermediate Image box and filling PPACs with gas] |
venting_pumping_intermediate_image_box [2018/12/19 11:10] pereira [Filling Intermediate-image delay PPAC] |
||
|---|---|---|---|
| Line 69: | Line 69: | ||
| * (Note: sometimes it is necessary to repeat this operation a couple of times). | * (Note: sometimes it is necessary to repeat this operation a couple of times). | ||
| * At the end of the procedure, close the manual roughing pump valve | * At the end of the procedure, close the manual roughing pump valve | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | ===== Filling Intermediate-image delay PPAC ===== | ||
| + | Requirements: | ||
| + | |||
| + | * Verify that PPACs are in automatic mode with gas removed (**S3_Gas_Handling**) | ||
| + | * The "GH System Status box should read "Auto Mode Gas Removed" | ||
| + | * If gas is removed but the system is not in the automatic mode, consult the Beam Physicists or Device | ||
venting_pumping_intermediate_image_box.txt ยท Last modified: 2024/01/12 09:37 by noji
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
