venting_pumping_intermediate_image_box
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
venting_pumping_intermediate_image_box [2024/01/11 10:14] noji [Venting the Chamber] |
venting_pumping_intermediate_image_box [2024/01/11 10:29] noji [Emptying Detectors] |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| ===== Emptying Detectors ===== | ===== Emptying Detectors ===== | ||
| - Set “PPAC Setpoint” to 0 Torr. | - Set “PPAC Setpoint” to 0 Torr. | ||
| - | - Click **EMPTY** on the “GHS_II-PPAC_Main” page to begin pumping out the gas quickly. | + | - Click **EMPTY** on the “GHS_II-PPAC_Main” page to open valves #3 and #4 which will allow for pumping out the gas quickly. |
| - When “PPAC Pressure” reads < 0.1 Torr, click **MAN** and then **AUTO**. This will release the remaining gas into the diagnostics box. | - When “PPAC Pressure” reads < 0.1 Torr, click **MAN** and then **AUTO**. This will release the remaining gas into the diagnostics box. | ||
| - Monitor D2340 pumping station and ensure the TMP stays on and TGV remains open. If not, contact the Vacuum Operation group. | - Monitor D2340 pumping station and ensure the TMP stays on and TGV remains open. If not, contact the Vacuum Operation group. | ||
venting_pumping_intermediate_image_box.txt · Last modified: 2024/01/12 09:37 by noji
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
