This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
division_of_operation_responsibilities [2015/10/28 06:55] pereira [Device Physicist] |
division_of_operation_responsibilities [2016/11/09 15:36] (current) pereira [User responsibilities that may need support from Device Physicist] |
||
---|---|---|---|
Line 4: | Line 4: | ||
==== Device Physicist ==== | ==== Device Physicist ==== | ||
+ | * General tuning of S800 (XDT) | ||
* Determining biases | * Determining biases | ||
* Operation of gas handling systems | * Operation of gas handling systems | ||
==== User ==== | ==== User ==== | ||
- | * [[Trigger#Trigger schematics|Trigger changes]] | + | * Trigger changes |
- | * [[Detectors#Ionization chamber|Ionization chamber]] calibration | + | * Installation of reaction targets in [[Stations|target area]] (pivot point) |
- | * Alarm monitoring and initial response | + | * [[Vacuum control#Target Chamber|Target chamber vacuum]] system operation |
- | * [[Stations|Target chamber (Pivot-point area)]] vacuum system operation | + | |
- | * [[During experiments#Mask calibration|Mask calibration]] | + | |
* Tracking efficiency of [[Detectors#Plastic scintillators|OBJ scintillator]] | * Tracking efficiency of [[Detectors#Plastic scintillators|OBJ scintillator]] | ||
* Instalation of video camera in the Pivot-point area | * Instalation of video camera in the Pivot-point area | ||
Line 19: | Line 18: | ||
==== User responsibilities that may need support from Device Physicist ==== | ==== User responsibilities that may need support from Device Physicist ==== | ||
* [[Magnetic-rigidity setting|Determination of magnetic rigidity for spectrograph settings]] | * [[Magnetic-rigidity setting|Determination of magnetic rigidity for spectrograph settings]] | ||
- | * Implementing TOF and energy loss based PID corrections | + | * [[During experiments#Particle Identification Corrections|Implementing PID corrections]] |
+ | * [[During experiments#Mask calibration|Mask calibration]] | ||
+ | * [[Vacuum control#Target chamber|Venting lower-dipole section (to install aligning telescope)]] | ||
In the absence of a S800 device physicist, please follow the official procedure for handing over the beam from the operators/beam physicists to the experimenters and vice versa: [[https://intra.nscl.msu.edu/ccf/infoexperimenters/handingoverbeam.php]]. | In the absence of a S800 device physicist, please follow the official procedure for handing over the beam from the operators/beam physicists to the experimenters and vice versa: [[https://intra.nscl.msu.edu/ccf/infoexperimenters/handingoverbeam.php]]. |