during_experiments
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
during_experiments [2017/06/17 14:47] pereira [During experiment] |
during_experiments [2017/06/17 14:53] pereira [Efficiency of OBJ Scintillator] |
||
|---|---|---|---|
| Line 96: | Line 96: | ||
| ===== Efficiency of OBJ Scintillator ===== | ===== Efficiency of OBJ Scintillator ===== | ||
| + | At relatively high rates (~0.5 MHz), the OBJ scintillator will be gradually damaged. Experimenters should check the efficiency of this detector continuously during the course of the experiment. Whenever the rates drop below ~90%, they may request the Device/Beam Physicist to shim the detector. | ||
| + | |||
| + | |||
| + | |||
| + | Before shimming, make sure that the thresholds are set properly (not too high) (refer to section " | ||
| + | |||
| ==== Shimming OBJ scintillator ==== | ==== Shimming OBJ scintillator ==== | ||
during_experiments.txt ยท Last modified: 2023/07/20 10:43 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
