installation_fp_sci
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
installation_fp_sci [2019/07/01 09:04] pereira [Vent focal-plane chamber] |
installation_fp_sci [2019/07/01 09:05] pereira [Vent focal-plane chamber] |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| {{: | {{: | ||
| * Close I265GV (gate valve separating FP box from rest of beam line) is closed. | * Close I265GV (gate valve separating FP box from rest of beam line) is closed. | ||
| - | * Click on the **VENT STATUS** window and begin the venting procedure. The **VENT VALVE I260VV** window will turn red and display " | + | * Click on the **VENT STATUS** window and begin the venting procedure. The **VENT VALVE I260VV** window will turn red and display " |
| * Gently open the manual venting valve until the pressure displayed in the Pirani Gauge (see figure below) increases by ~1 torr every 15 seconds (see figures below) | * Gently open the manual venting valve until the pressure displayed in the Pirani Gauge (see figure below) increases by ~1 torr every 15 seconds (see figures below) | ||
| {{: | {{: | ||
installation_fp_sci.txt ยท Last modified: 2023/08/18 10:19 by noji
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
