This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
preparation_for_tuning_the_s800 [2013/12/14 16:30] pereira |
preparation_for_tuning_the_s800 [2015/10/27 09:32] (current) pereira |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Preparation for tuning ====== | ====== Preparation for tuning ====== | ||
- | * [[Software|Software | + | |
+ | | ||
+ | * [[S800 DAQ tools]] | ||
* [[Electronics overview|Electronics, | * [[Electronics overview|Electronics, | ||
+ | * [[Vacuum control]] | ||
* [[Gas handling system]] | * [[Gas handling system]] | ||
* [[HV bias]] | * [[HV bias]] | ||
Line 9: | Line 12: | ||
- | PREPARATION FOR TUNING | ||
- | In S3 vault | ||
- | Arm dump switches | ||
- | Make sure object ion gauge is off | ||
- | Go to page xx on Panel Mate xxx. Check status xxx | ||
- | | ||
- | Make sure gas bottles for FP detectors are open | ||
- | Make sure Intermediate PPACs have gas | ||
- | |||
- | In data-U | ||
- | Start Software tools | ||
- | PanelMates | ||
- | NMR GUIs | ||
- | Barney | ||
- | Labview Gas Handling System Controls | ||
- | Labview Bias Controls | ||
- | Alarm servers and monitors | ||
- | Linux HV controls (alarm server should be started first) | ||
- | SpecTcl (alart server should be started first) | ||
- | Run Control (in coordination with experimenters) | ||
- | Trigger Control GUI (in coordination with experimenters) | ||
- | Scalers (in coordination with experimenters) | ||
- | Put 10 Amps in Spectrograph dipoles | ||
- | |||
- | Start gas in detectors | ||
- | Refer to Section xx (S800 Focal Plane Gas Handling System Operation) | ||
- | |||
- | Enable crad04 with a rate limit of 20 kHz (crad04 looks at E1 up) | ||
- | If it does not interfere with experimenter preparation (see “Unreacted Beam” section below) | ||
- | Set spectrograph Brho | ||
- | Start scalers | ||