Differences

This shows you the differences between two versions of the page.

--- s800_daq_tools [2023/10/19 17:23]
swartzj [Running in Slave mode with multilogger]
+++ s800_daq_tools [2023/10/19 17:25] (current)
swartzj [Running in Slave mode with multilogger]
@@ Line 107: / Line 107: @@
-By default, when running in Slave mode, data are recorded in the stagearea of the Master DAQ (experiment account). It is however possible to record simultaneously data from the S800 into the S800 stagearea, using the ''multilogger'' option (see ReadoutGUI figure above). The S800 ReadoutGUI offers the possibility to record data from four different S800 ring-buffers: rawccusb, rawvmusb, s800built, and s800filter. The later is the most important since data from this ring buffer can be immediately processed by the S800 SpecTcl.
+By default, when running in Slave mode, data are recorded in the stagearea of the Master DAQ (experiment account). It is however possible to record simultaneously data from the S800 into the S800 stagearea, using the ''multilogger'' option (see ReadoutGUI figure above). The S800 ReadoutGUI offers the possibility to record data from four different S800 ring-buffers: rawccusb, rawvmusb, s800built, and s800filter. The latter is the most important since data from this ring buffer can be immediately processed by the S800 SpecTcl.
 When running XDT for an experiment with a Master DAQ (e.g. GRETINA), it is recommendable to run the S800 DAQ in Slave mode with the s800filter multilogger enabled. This can be done following the steps:

S800 Documentation