s800_daq_tools
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
s800_daq_tools [2023/04/20 15:43] swartzj |
s800_daq_tools [2023/08/07 16:16] swartzj |
||
|---|---|---|---|
| Line 168: | Line 168: | ||
| ==== For hodoscope runs, cannot read signal from hodoscope ==== | ==== For hodoscope runs, cannot read signal from hodoscope ==== | ||
| If you see this kind error message when starting the DAQ with the hodoscope in the trigger (Ext. 1 in ULM gui), check the voltages on the crate which holds the hodoscope shaper modules. If they are not at the correct values, follow this procedure: | If you see this kind error message when starting the DAQ with the hodoscope in the trigger (Ext. 1 in ULM gui), check the voltages on the crate which holds the hodoscope shaper modules. If they are not at the correct values, follow this procedure: | ||
| - | - Ordered List ItemTurn | + | - Turn crate off |
| - Unplug both shapers (for both hodoscopes). Just pull them but don’t fully remove the cards. | - Unplug both shapers (for both hodoscopes). Just pull them but don’t fully remove the cards. | ||
| - With shapers unplugged, turn crate on and check voltages | - With shapers unplugged, turn crate on and check voltages | ||
s800_daq_tools.txt · Last modified: 2023/10/19 17:25 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
