timing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
timing [2016/08/01 13:01] pereira [Timing] |
timing [2019/05/24 14:10] pereira |
||
|---|---|---|---|
| Line 38: | Line 38: | ||
| ^ E1 up ^ 14 | LeCroy Var. ampl. -> Mesytec MCFD ch #0 -> ECL-NIM -> Fan in/out -> Fan in/out -> Fan in/out -> NIM-ECL | | ^ E1 up ^ 14 | LeCroy Var. ampl. -> Mesytec MCFD ch #0 -> ECL-NIM -> Fan in/out -> Fan in/out -> Fan in/out -> NIM-ECL | | ||
| ^ E1 up ^ 15 | LeCroy Var. ampl. -> Mesytec MCFD ch #0 -> ECL-NIM -> Fan in/out -> Fan in/out -> NIM-ECL | | ^ E1 up ^ 15 | LeCroy Var. ampl. -> Mesytec MCFD ch #0 -> ECL-NIM -> Fan in/out -> Fan in/out -> NIM-ECL | | ||
| + | ^ II PPAC2 anode ^ 16 | Mesytec MCFD2 ch #0 | | ||
| + | ^ II PPAC2 down ^ 17 | Mesytec MCFD2 ch #1 | | ||
| + | ^ II PPAC2 up ^ 18 | Mesytec MCFD2 ch #2 | | ||
| + | ^ II PPAC2 right ^ 19 | Mesytec MCFD2 ch #3 | | ||
| + | ^ II PPAC2 left ^ 20 | Mesytec MCFD2 ch #4 | | ||
| + | ^ II PPAC1 anode ^ 21 | Mesytec MCFD2 ch #5 | | ||
| + | ^ II PPAC1 down ^ 22 | Mesytec MCFD2 ch #6 | | ||
| + | ^ II PPAC1 up ^ 23 | Mesytec MCFD2 ch #7 | | ||
| + | ^ II PPAC1 right ^ 24 | Mesytec MCFD2 ch #8 | | ||
| + | ^ II PPAC1 left ^ 25 | Mesytec MCFD2 ch #9 | | ||
| + | |||
| The multi-hit capability requires some special attention. Let's imagine a situation where the rate from OBJ detector is much higher than from the FP detector. During this window, the MTDC will record one hit from the FP scintillator (E1 up, which SpecTcl uses as the start ToF reference) and multiple hits from the OBJ scintillator (stops). As a results, SpecTcl will generate an array of OBJ-FP ToFs called **s800.fp.vmetdc.obj.i**, | The multi-hit capability requires some special attention. Let's imagine a situation where the rate from OBJ detector is much higher than from the FP detector. During this window, the MTDC will record one hit from the FP scintillator (E1 up, which SpecTcl uses as the start ToF reference) and multiple hits from the OBJ scintillator (stops). As a results, SpecTcl will generate an array of OBJ-FP ToFs called **s800.fp.vmetdc.obj.i**, | ||
timing.txt ยท Last modified: 2020/04/02 20:58 by pereira
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
