timing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
timing [2019/05/24 14:10] pereira |
timing [2019/05/24 14:11] pereira [Phillips TDC] |
||
|---|---|---|---|
| Line 83: | Line 83: | ||
| ==== Phillips TDC ==== | ==== Phillips TDC ==== | ||
| + | **ATTENTION: | ||
| + | |||
| * Before going to the TDC, the OBJ and XFP detector signals are sent to a {{: | * Before going to the TDC, the OBJ and XFP detector signals are sent to a {{: | ||
| * The TDC start is provided by the [[Trigger|ULM trigger module]]. Since the delay of the S800 trigger may be adjusted during tuning of the S800 (XDT), the stop signals (e.g. from OBJ or XFP) need to be re-adjusted so that the ToF fits into the 400-ns range of the TDC. This is done manually for OBJ and XFP, and remotely via [[XLM Delay|XLM delay module]] (operated by the [[S800 DAQ tools#Delay Window|Delay GUI]]) for other timing signals | * The TDC start is provided by the [[Trigger|ULM trigger module]]. Since the delay of the S800 trigger may be adjusted during tuning of the S800 (XDT), the stop signals (e.g. from OBJ or XFP) need to be re-adjusted so that the ToF fits into the 400-ns range of the TDC. This is done manually for OBJ and XFP, and remotely via [[XLM Delay|XLM delay module]] (operated by the [[S800 DAQ tools#Delay Window|Delay GUI]]) for other timing signals | ||
timing.txt ยท Last modified: 2020/04/02 20:58 by pereira
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
