This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
to-do_list [2015/10/19 14:45] pereira [In data U6] |
to-do_list [2018/05/02 16:36] pereira [In data U6] |
||
---|---|---|---|
Line 21: | Line 21: | ||
===== In data U6 ===== | ===== In data U6 ===== | ||
* Start [[Software# | * Start [[Software# | ||
- | + | ||
+ | * Source the environment file to run the DAQ: | ||
+ | * Open a terminal in u6pc5 and type '' | ||
+ | * Type '' | ||
+ | |||
+ | * Verify with S800 Device Physicist that S800 DAQ has been installed and it is ready for the experiment. S800 DAQ can be installed by typing command '' | ||
+ | |||
+ | |||
+ | * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing '' | ||
+ | |||
+ | * Set S800 DAQ in [[s800 daq tools# | ||
+ | |||
+ | * Check [[s800 daq tools# | ||
* [[Turning magnets on/off#Set magnet currents individually |Put 10 Amps in Spectrograph dipoles]] | * [[Turning magnets on/off#Set magnet currents individually |Put 10 Amps in Spectrograph dipoles]] | ||