Differences

This shows you the differences between two versions of the page.

--- to-do_list [2015/10/28 06:54]
pereira
+++ to-do_list [2017/06/16 19:08]
pereira [In data U6]
@@ Line 26: / Line 26: @@
         * Type ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where xxxx is the nscldaq version number (11.0-015 on Oct 26, 2015)
-  * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing ''ls -l ~/stagearea'' in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, follow the following steps:
+  * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing ''ls -l ~/stagearea'' in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, run script **goinstall** from any directory, and follow the intructions. After that, verify that the stagearea is correct.
-        * Create a experiment directory in **/mnt/daqtesting/s800** by typing ''mkdir exxxxx''
-        * Go to the newly created experiment directory, and create subdirectories **s800built**, **rawccusb**, and **rawvmusb**
-        * Remove the old stagearea link ''rm ~/stagearea''
-        * Create a new stagearea link by typing ''ln -s /mnt/daqtesting/s800/exxxxx stagearea''
-        * Run the S800 DAQ with multilogger enabled, and take some data on disk to ensure that the newly created stagearea is properly filled
+  * Set S800 DAQ in [[s800 daq tools#Running in Slave mode with multilogger |Slave mode and enable multilogger]] to record S800 data in the s800 stagearea.
   * Check [[s800 daq tools#scaler display|scalers]] while running S800 DAQ
   * [[Turning magnets on/off#Set magnet currents individually |Put 10 Amps in Spectrograph dipoles]]

S800 Documentation

User Tools

Site Tools

Differences

Page Tools