This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
to-do_list [2017/04/06 10:48] pereira |
to-do_list [2019/03/13 21:24] pereira [In data U6] |
||
---|---|---|---|
Line 23: | Line 23: | ||
* Source the environment file to run the DAQ: | * Source the environment file to run the DAQ: | ||
- | * Open a terminal in u6pc5 and type '' | + | * Open a terminal in u6pc5 and type '' |
* Type '' | * Type '' | ||
- | * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing '' | + | * Verify |
- | * Check [[s800 daq tools# | + | |
+ | |||
+ | * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing '' | ||
+ | |||
+ | * Set S800 DAQ in [[s800 daq tools# | ||
+ | |||
+ | * Check [[s800 daq tools# | ||
* [[Turning magnets on/off#Set magnet currents individually |Put 10 Amps in Spectrograph dipoles]] | * [[Turning magnets on/off#Set magnet currents individually |Put 10 Amps in Spectrograph dipoles]] | ||
Line 39: | Line 44: | ||
* [[Magnetic-rigidity setting|Set spectrograph Brho]] (coordinate with experimenters) | * [[Magnetic-rigidity setting|Set spectrograph Brho]] (coordinate with experimenters) | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ===== At the end of the experiment ===== | ||
+ | * Verify with S800 Device Physicist that S800 DAQ software is uninstalled. This can be done by typing script '' | ||
+ | |||
+ | * Unbias detectors, CRDC interface boards, CRDCs gate, etc | ||
+ | |||
+ | * [[Gas handling system|Remove gas]] from CRDCs and Ion Chamber | ||