Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
Next revision
Both sides next revision
|
to-do_list [2017/06/16 19:08] pereira [In data U6] |
to-do_list [2017/06/16 19:08] pereira [In data U6] |
* Verify that **stagearea** in u6pc5 is pointing to the right place. After typing ''ls -l ~/stagearea'' in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, run script **goinstall** from any directory, and follow the intructions. After that, verify that the stagearea is correct. | * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing ''ls -l ~/stagearea'' in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, run script **goinstall** from any directory, and follow the intructions. After that, verify that the stagearea is correct. |
| |
* Set S800 DAQ in [[s800 daq tools#Running in Slave mode with multilogger |Slave mode and enable multilogger]] for **s800filter** | * Set S800 DAQ in [[s800 daq tools#Running in Slave mode with multilogger |Slave mode and enable multilogger]] to record S800 data in the s800 stagearea. |
| |
* Check [[s800 daq tools#scaler display|scalers]] while running S800 DAQ | * Check [[s800 daq tools#scaler display|scalers]] while running S800 DAQ |