This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
to-do_list [2023/05/08 14:28] noji [In data U6] |
to-do_list [2023/10/19 17:12] swartzj |
||
---|---|---|---|
Line 7: | Line 7: | ||
* [[Installation FP SCI|Install the focal-plane scintillator]] with the right thickness (1mm or 5mm) | * [[Installation FP SCI|Install the focal-plane scintillator]] with the right thickness (1mm or 5mm) | ||
- | * Ensure that the object scintillator is in good conditions | + | * Ensure that the object scintillator is in good condition |
* [[Turning magnets on off#Arming of Dump Switch|Arm dump switches]] | * [[Turning magnets on off#Arming of Dump Switch|Arm dump switches]] | ||
Line 20: | Line 20: | ||
===== In data U4 ===== | ===== In data U4 ===== | ||
- | * Start [[Software#u6pc5 (data U6)|Software applications]] (in computer | + | * Start [[Software#u4pc8 (data U4)|Software applications]] (in computer |
==== Setting up DAQ software ==== | ==== Setting up DAQ software ==== | ||
Line 40: | Line 40: | ||
* '' | * '' | ||
- | * The script should relink **stagearea** to the right place, provided that the proper experimental number is given. After typing '' | + | * The script should relink **stagearea** to the right place, provided that the proper experimental number is given. After typing '' |
=== Set S800 DAQ mode === | === Set S800 DAQ mode === |