to-do_list
This is an old revision of the document!
Table of Contents
To-Do list
This section is aimed at helping the Device Physicist remember the list of things that need to be done prior to the S800 tuning.
In S3 vault
- Install the focal-plane scintillator with the right thickness (1mm or 5mm)
- Ensure that the object scintillator is in good conditions and has enough shimming positions to withstand the expected rates during the course of the experiment. The guideline document describing the installation and shimming procedure can be accessed here
- Ensure viewer is ready in S800 target station (pivot point)
- Make sure gas bottles for FP detectors are open
- Make sure Intermediate PPACs have gas
In data U6
- Start Software applications (in computer u6pc5)
- Enable CRAD04 with a rate limit of 20 kHz (CRAD04 looks at E1 up FP scintillator) via PanelMate CRAD_RF_Intlks.ui (PAGE 01) located in directory \\exp\files\control\ncsdata\General\Qt\Templates
- Set spectrograph Brho (coordinate with experimenters)
to-do_list.1445276146.txt.gz · Last modified: 2015/10/19 13:35 by pereira
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
