This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
troubleshooting [2015/08/31 10:11] pereira |
troubleshooting [2015/10/23 11:03] pereira |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Troubleshooting ====== | ====== Troubleshooting ====== | ||
- | + | * Problems to start DAQ | |
- | * Restarting | + | One of the most common reasons why the S800 DAQ fails to start is because the CCUSB and/or VMUSB are claimed by existing programs. This is shown by the error messages displayed by the system. If you find yourself in this situation try the following: |
+ | - Log on to S800 spdaq (spdaq19 as of October 2015) | ||
+ | - Type '' | ||
+ | - Use '' | ||
+ | - Use '' | ||
+ | - Try '' | ||
+ | - If this didn't help try rebooting the S800 DAQ manually (see below) | ||
+ | | ||
+ | * [[Software|Access to S800 software account]] | ||
* [[S800 DAQ tools# | * [[S800 DAQ tools# | ||
- | * NMR | + | * [[NMR probes# |
- | * | + | * [[Turning magnets on/off#Turn on S800 magnets power supply|Problems to turn on magnets power supply]] |