tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
tuning_the_s800_xdt [2023/09/22 14:48] swartzj [FP scintillator setup] |
tuning_the_s800_xdt [2023/09/22 14:51] swartzj [CRDCs setup] |
||
|---|---|---|---|
| Line 123: | Line 123: | ||
| * **[[hv bias#hv remote control|Bias]]** CRDCs | * **[[hv bias#hv remote control|Bias]]** CRDCs | ||
| * Look at anode signal on **[[electronics overview|scope]]** | * Look at anode signal on **[[electronics overview|scope]]** | ||
| - | * Patched to data-U6 on labeled connector | + | * Patched to data-U4 on labeled connector |
| * **200 – 500 mV** signals are good | * **200 – 500 mV** signals are good | ||
| * CRDC1 anode is noisier (digital noise) than CRDC2 | * CRDC1 anode is noisier (digital noise) than CRDC2 | ||
| Line 137: | Line 137: | ||
| * Count rate is a little higher than on scintillator due to noise or thresholds | * Count rate is a little higher than on scintillator due to noise or thresholds | ||
| - | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** (see figure below), or, alternatively **S800_MEGASUMMARY.win** to verify the good performance of the detectors. (The spectra for each CRDC can be checked | + | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** (see figure below), or, alternatively **S800_MEGASUMMARY.win** to verify the good performance of the detectors. (The spectra for each CRDC can be checked |
| * Spectra **crdc1.raws** and **crdc2.raws** | * Spectra **crdc1.raws** and **crdc2.raws** | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
