tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
tuning_the_s800_xdt [2023/09/22 14:50] swartzj [CRDCs setup] |
tuning_the_s800_xdt [2023/09/22 15:15] swartzj [CRDCs setup] |
||
|---|---|---|---|
| Line 137: | Line 137: | ||
| * Count rate is a little higher than on scintillator due to noise or thresholds | * Count rate is a little higher than on scintillator due to noise or thresholds | ||
| - | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** (see figure below), or, alternatively **S800_MEGASUMMARY.win** to verify the good performance of the detectors. (The spectra for each CRDC can be checked | + | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** (see figure below), or, alternatively **S800_MEGASUMMARY.win** to verify the good performance of the detectors. (The spectra for each CRDC can be checked |
| * Spectra **crdc1.raws** and **crdc2.raws** | * Spectra **crdc1.raws** and **crdc2.raws** | ||
| Line 177: | Line 177: | ||
| * Make a summing region around the " | * Make a summing region around the " | ||
| * Stop the run and rescan data from disk | * Stop the run and rescan data from disk | ||
| - | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the later (nearly 100% efficiency for medium/high Z) | + | * Compare the number of event inside the 2D summing regions with the number of events inside the **ic** gate. Typically the former are very close to the latter |
| {{: | {{: | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
