This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
turning_magnets_on_off [2015/10/19 13:44] pereira [Turn on S800 magnets power supply] |
turning_magnets_on_off [2015/10/19 15:23] pereira |
||
---|---|---|---|
Line 28: | Line 28: | ||
===== Turn on S800 magnets power supply ===== | ===== Turn on S800 magnets power supply ===== | ||
+ | * **Troubleshooting**: | ||
+ | |||
+ | {{: | ||
+ | |||
* Open the NCS PanelMate application and load file **THallps.ui**, | * Open the NCS PanelMate application and load file **THallps.ui**, | ||
Line 40: | Line 44: | ||
- | * **Troubleshooting**: | ||
- | |||
- | {{: | ||
===== Set S800 magnets settings ===== | ===== Set S800 magnets settings ===== | ||
Line 59: | Line 60: | ||
* Ensure that the current in the dipoles are properly matched to the desired values (see section on [[NMR probes# | * Ensure that the current in the dipoles are properly matched to the desired values (see section on [[NMR probes# | ||
+ | |||
+ | * Note: The currents in the Trim coils will be set automatically in Barney, once the rigidity in Segment 8 was entered. | ||
===== Set magnet currents individually ===== | ===== Set magnet currents individually ===== | ||
- | **NOTE: | + | The values of currents for the different magnets can be modified individually by clicking the button " |
| | ||
+ | {{: | ||
===== Turn on the trim coils of the Spectrograph dipoles ===== | ===== Turn on the trim coils of the Spectrograph dipoles ===== | ||
+ | Note: The following procedure describes how to set the trim-coil currents manually. In principle, it is no longer necessary because Barney sets the currents automatically once the rigidity of segment 8 has been entered. | ||
+ | |||
* Check the currents in the Spectrograph dipoles by looking at the EPICS channels I265DS and I269DS. This can be done e.g. by clicking the button **Details** in segment 8 of the S800 Barney page (see figure below) | * Check the currents in the Spectrograph dipoles by looking at the EPICS channels I265DS and I269DS. This can be done e.g. by clicking the button **Details** in segment 8 of the S800 Barney page (see figure below) |