S800 Documentation

User Tools

Site Tools

Trace:
turning_magnets_on_off

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
turning_magnets_on_off [2015/10/19 14:46]
pereira [Set S800 magnets settings] 		turning_magnets_on_off [2015/10/19 15:23]
pereira
Line 28: Line 28:
  
 ===== Turn on S800 magnets power supply ===== ===== Turn on S800 magnets power supply =====
 +  * **Troubleshooting**: if a power supply cannot be turned on from PanelMate, check that the power supply module is ON. The modules for all S800 magnets are located in the S3 vault on the middle level under the stairs to the top level (see figure below). If all the modules seem to be running properly, but the problem persists, contact the operators in Control Room, ext. 305.
 +
 +{{:wiki:power-supply-magnets.jpg?450|Power supply modules}} 
 +
  
   * Open the NCS PanelMate application and load file **THallps.ui**, in directory \\exp\files\control\ncsdata\General\Qt\Templates.   * Open the NCS PanelMate application and load file **THallps.ui**, in directory \\exp\files\control\ncsdata\General\Qt\Templates.
Line 40: Line 44:
  
  
-  * **Troubleshooting**: if a power supply cannot be turned on from PanelMate, check that the power supply module is ON. The modules for all S800 magnets are located in the S3 vault on the middle level under the stairs to the top level (see figure below).  
- 
-{{:wiki:power-supply-magnets.jpg?600|Power supply modules}}  
  
 ===== Set S800 magnets settings ===== ===== Set S800 magnets settings =====
Line 70: Line 71:
  
 =====  Turn on the trim coils of the Spectrograph dipoles =====   =====  Turn on the trim coils of the Spectrograph dipoles =====  
 +Note: The following procedure describes how to set the trim-coil currents manually. In principle, it is no longer necessary because Barney sets the currents automatically once the rigidity of segment 8 has been entered.
 +
  
        * Check the currents in the Spectrograph dipoles by looking at the EPICS channels I265DS and I269DS. This can be done e.g. by clicking the button **Details** in segment 8 of the S800 Barney page (see figure below)        * Check the currents in the Spectrograph dipoles by looking at the EPICS channels I265DS and I269DS. This can be done e.g. by clicking the button **Details** in segment 8 of the S800 Barney page (see figure below)
turning_magnets_on_off.txt ยท Last modified: 2019/05/15 11:58 by pereira

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki