Differences

This shows you the differences between two versions of the page.

--- turning_magnets_on_off [2015/10/19 14:49]
pereira [Turn on the trim coils of the Spectrograph dipoles]
+++ turning_magnets_on_off [2015/10/19 15:23]
pereira
@@ Line 28: / Line 28: @@
 ===== Turn on S800 magnets power supply =====
+  * **Troubleshooting**: if a power supply cannot be turned on from PanelMate, check that the power supply module is ON. The modules for all S800 magnets are located in the S3 vault on the middle level under the stairs to the top level (see figure below). If all the modules seem to be running properly, but the problem persists, contact the operators in Control Room, ext. 305.
+{{:wiki:power-supply-magnets.jpg?450|Power supply modules}}
   * Open the NCS PanelMate application and load file **THallps.ui**, in directory \\exp\files\control\ncsdata\General\Qt\Templates.
@@ Line 40: / Line 44: @@
-  * **Troubleshooting**: if a power supply cannot be turned on from PanelMate, check that the power supply module is ON. The modules for all S800 magnets are located in the S3 vault on the middle level under the stairs to the top level (see figure below).
-{{:wiki:power-supply-magnets.jpg?600|Power supply modules}}
 ===== Set S800 magnets settings =====

S800 Documentation