Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
Next revision
Both sides next revision
|
turning_magnets_on_off [2015/10/19 15:19] pereira [Turn on S800 magnets power supply] |
turning_magnets_on_off [2015/10/19 15:23] pereira |
| |
===== Turn on S800 magnets power supply ===== | ===== Turn on S800 magnets power supply ===== |
* **Troubleshooting**: if a power supply cannot be turned on from PanelMate, check that the power supply module is ON. The modules for all S800 magnets are located in the S3 vault on the middle level under the stairs to the top level (see figure below). | * **Troubleshooting**: if a power supply cannot be turned on from PanelMate, check that the power supply module is ON. The modules for all S800 magnets are located in the S3 vault on the middle level under the stairs to the top level (see figure below). If all the modules seem to be running properly, but the problem persists, contact the operators in Control Room, ext. 305. |
| |
{{:wiki:power-supply-magnets.jpg?450|Power supply modules}} | {{:wiki:power-supply-magnets.jpg?450|Power supply modules}} |