cobo_testing
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
cobo_testing [2014/05/22 09:54] – abunimeh | cobo_testing [2014/12/08 13:41] – [Power] abunimeh | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Hardware Requirements ====== | ||
+ | * µTCA crate equipped with MCH, JTAG modules, 1KW power supply | ||
+ | * CoBo v1.0 AMC | ||
+ | * 4 x AsAd boards, 4 x VHDCI cables and 4 x power cables | ||
+ | * Power supply 3.6V 6A minimum for Asads | ||
+ | * PC running Fedora, connected via Ethernet to MCH | ||
+ | * Xilinx JTAG programmer USB brick | ||
+ | * Micro-USB cable | ||
+ | |||
+ | |||
+ | ====== Software Requirements ====== | ||
+ | * NXP LPC chip should be flashed with VadaTech software | ||
+ | * FRU and SDR should have correct values | ||
+ | * Xilinx v14.7 tools should be installed on PC (xmd) | ||
+ | * GetController software suite should be installed on PC | ||
+ | * PC needs to run some version of DHCP server (dnsmasq), as well as NFS server. | ||
+ | |||
====== Power ====== | ====== Power ====== | ||
+ | Click on Image below to see voltage test points. | ||
+ | {{: | ||
====== LEDs ====== | ====== LEDs ====== | ||
====== UART ====== | ====== UART ====== | ||
Line 8: | Line 27: | ||
====== Ethernet ====== | ====== Ethernet ====== | ||
====== GET testing ====== | ====== GET testing ====== | ||
+ | ====== Mechanical ====== | ||
cobo_testing.txt · Last modified: 2014/12/08 13:41 by abunimeh