cobo_testing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| cobo_testing [2014/05/22 09:54] – abunimeh | cobo_testing [2014/12/08 13:41] – [Power] abunimeh | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Hardware Requirements ====== | ||
| + | * µTCA crate equipped with MCH, JTAG modules, 1KW power supply | ||
| + | * CoBo v1.0 AMC | ||
| + | * 4 x AsAd boards, 4 x VHDCI cables and 4 x power cables | ||
| + | * Power supply 3.6V 6A minimum for Asads | ||
| + | * PC running Fedora, connected via Ethernet to MCH | ||
| + | * Xilinx JTAG programmer USB brick | ||
| + | * Micro-USB cable | ||
| + | |||
| + | |||
| + | ====== Software Requirements ====== | ||
| + | * NXP LPC chip should be flashed with VadaTech software | ||
| + | * FRU and SDR should have correct values | ||
| + | * Xilinx v14.7 tools should be installed on PC (xmd) | ||
| + | * GetController software suite should be installed on PC | ||
| + | * PC needs to run some version of DHCP server (dnsmasq), as well as NFS server. | ||
| + | |||
| ====== Power ====== | ====== Power ====== | ||
| + | Click on Image below to see voltage test points. | ||
| + | {{: | ||
| ====== LEDs ====== | ====== LEDs ====== | ||
| ====== UART ====== | ====== UART ====== | ||
cobo_testing.txt · Last modified: 2014/12/08 13:41 by abunimeh