Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
daq:daq [2019/11/27 14:33] jing [Reboot a2] |
daq:daq [2020/07/15 16:11] jing [Troubleshoot] |
||
---|---|---|---|
Line 7: | Line 7: | ||
======= Troubleshoot ====== | ======= Troubleshoot ====== | ||
* S800-Gretina not correlated: Check CC setfile ~s800/converged_daq/Scripts/CC0105Begin.tcl for extsynch and extclock | * S800-Gretina not correlated: Check CC setfile ~s800/converged_daq/Scripts/CC0105Begin.tcl for extsynch and extclock | ||
+ | * S800 is losing events. Check the network speed of spdaq45 by /sbin/ethtool eth0 and /sbin/ethtool eth1 , both should show speed as 1000Mb/s, if one shows 100Mb/s then the network is too slow and S800 cannot send data to GEB fast enough which will cause event loss happen. | ||
+ | * Check the ringbuffer status, $DAQBIN/ringbuffer status - -host=spdaq45 - -all , if the free colum becomes zero, DAQ related people needs to be notified for diagnostics. | ||
======= Decomp Information ====== | ======= Decomp Information ====== | ||
Line 40: | Line 42: | ||
* Check digitizer firmware version: on a2 or a1 terminal, type: **DIGSNIDFW** ,all digitizers should have same version firmware | * Check digitizer firmware version: on a2 or a1 terminal, type: **DIGSNIDFW** ,all digitizers should have same version firmware | ||
* [[Replace digitizer with different color ones]] | * [[Replace digitizer with different color ones]] | ||
+ | * [[Replace fuses of digitizer]] | ||
+ | * [[No valid decomposed events]] | ||
+ | * Verify connecedt digitizers, at IOC interface, type **dbior**, it will print all identified digitizers within one bank | ||
+ | * VME related scripts are located at /global/devel/boot/vmeArray | ||
+ | * Check connected PVs, at IOC interface, type "casr" | ||
====== Reboot a2 ====== | ====== Reboot a2 ====== |