Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
daq:decomp_calibrations [2017/02/27 12:38] peter_bender |
daq:decomp_calibrations [2017/02/27 12:54] peter_bender |
||
|---|---|---|---|
| Line 234: | Line 234: | ||
| </code> | </code> | ||
| + | Once the new setfile is edited to point to the newly created Decomp files, we must tell the gretina daq to load use this new setfile. This is done by editing the file **~gretina/grdecomp.sh** In the file, the parameter FILECONF should be edited to point to the newly created setfile. This parameter is at the top of the file in the first uncommented line. The convention is to copy the line, comment out the old definition, and change the setfile name in the new line. | ||
| + | |||
| + | |||
| + | == Loading new Decomp Parameters == | ||
| + | |||
| + | Once all the above is done, we must tell the daq to load the new decomp values. This can be done either using the buttons, **GRETINA Stand Alone** of **GRETINA + S800**, or by running the script **~gretina/grdecomp.sh** directly. | ||
| + | |||
| + | After the above load - the daq should be started and left to run for a few minutes. If there is some mistake in the loading of the above files, this will cause the buffers for the bad channels to fill up and the daq will stall. | ||
