====== Manual BOOT procedure ======
  * Switch ON the VME crate with the trigger board
  * wait 2 minutes
  * Switch ON all the VME crates of the digitizers
  * wait for green stable lights on the digitizers front panel (~ 2 minutes)
  * @op3: 
      * **cd scripts**
      * **./CheckTS4.sh**
      * For every digitizer timestamp error reported identify the IOC failing dividing the digitizer number by 4 and adding 1 and (the following example works for IOC#__12__):
          * **ssh gsoper:70__12__@10.0.0.11**
          * pw:
          * push <enter> again
          * if you get a prompt like this **vme12->** 
            * then give the command **<fix** 
            * else push CTRL-x
          * wait that the procedure end (~ 2 minutes)
          * exit from the IOC control by pushing **~.** (tilde dot)
      * Iterate the previous procedure till ./CheckTS4.sh reports that all the timestamps of the digitizers are OK
      * **cd**
      * **gt**
      * **cd 11-1/gretClust/bin/linux-x86**
      * **$PWD/godaq**
  * @gretina command line window:
      * **2**
      * **4**
      * **4b**
      * **3**
  * @op3:
      * **./setup7modulesRaw.sh**
  * @gretina command line window:
      * **8**
      * **6**
  * @gretina DAQ top level
      * push cluster
         * push nodes
            * if not all the processes are green
              * then 
                * delete the red process name (SendRaw)
                * push <enter>
                * write the process name (SendRaw)
                * push <enter>
      * push scripts
         * push the Set button close to "Setup for Calibration" 
  * @gretina RUN control
    * push start