Manual BOOT procedure

Switch ON the VME crate with the trigger board
wait 2 minutes
Switch ON all the VME crates of the digitizers
wait for green stable lights on the digitizers front panel (~ 2 minutes)
@op3:
- cd scripts
- ./CheckTS4.sh
- For every digitizer timestamp error reported identify the IOC failing dividing the digitizer number by 4 and adding 1 and (the following example works for IOC#12):
  - ssh gsoper:7012@10.0.0.11
  - pw:
  - push <enter> again
  - if you get a prompt like this vme12→
    - then give the command <fix
    - else push CTRL-x
  - wait that the procedure end (~ 2 minutes)
  - exit from the IOC control by pushing ~. (tilde dot)
- Iterate the previous procedure till ./CheckTS4.sh reports that all the timestamps of the digitizers are OK
- cd
- gt
- cd 11-1/gretClust/bin/linux-x86
- $PWD/godaq
@gretina command line window:
- 2
- 4
- 4b
- 3
@op3:
- ./setup7modulesRaw.sh
@gretina command line window:
- 8
- 6
@gretina DAQ top level
- push cluster
  - push nodes
    - if not all the processes are green
      - then
        
        delete the red process name (SendRaw)
        
        push <enter>
        
        write the process name (SendRaw)
        
        push <enter>
- push scripts
  - push the Set button close to “Setup for Calibration”
@gretina RUN control
- push start