Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
fillsystem:alarmresponse [2013/05/23 08:53] weisshaa |
fillsystem:alarmresponse [2014/02/27 16:14] 127.0.0.1 external edit |
||
|---|---|---|---|
| Line 34: | Line 34: | ||
| * IMPORTANT: detector T increased by few Kelvin only, see example plot below. | * IMPORTANT: detector T increased by few Kelvin only, see example plot below. | ||
| * Run run-gln-ui.sh | * Run run-gln-ui.sh | ||
| - | * Say 'fill det# now', confirm that you want to fill it. | + | * Say 'fill det#', confirm that you really want to fill it. |
| * Say 'coff det#', this stops T checking (and alarming and disabling) of this detector | * Say 'coff det#', this stops T checking (and alarming and disabling) of this detector | ||
| * Watch the fill, check for reasonable fill time (not that LN out is triggering much too early) | * Watch the fill, check for reasonable fill time (not that LN out is triggering much too early) | ||
| Line 40: | Line 40: | ||
| * If T is good say 'con #det', so T checking is enabled again. | * If T is good say 'con #det', so T checking is enabled again. | ||
| * If it is deep in the night: You can temporary increase T high threshold (F3 directive) | * If it is deep in the night: You can temporary increase T high threshold (F3 directive) | ||
| - | * NEVER LEAVE DETECTOR T CHECK OFF | + | * NEVER LEAVE DETECTOR T CHECKED OFF |
