Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
fillsystem:alarmresponse [2014/02/27 16:14] 127.0.0.1 external edit |
fillsystem:alarmresponse [2019/06/07 09:14] weisshaa |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| Type help for getting overview on commands. Get familiar with the commands mon, clr, ton, fill, coff, con, abort, load, quit | Type help for getting overview on commands. Get familiar with the commands mon, clr, ton, fill, coff, con, abort, load, quit | ||
| - | In some cases you need to edit the fill-system configuration file ~/gln/gln.fig for setting new temperature thresholds. In order | + | In some cases you need to edit the fill-system configuration file ~/scripts/gln.fig for setting new temperature thresholds. In order |
| to apply new gln.fig configuration you need to say 'load' in run-gln-ui.sh and MUST RE-ENABLE the filling! You can't say 'load' | to apply new gln.fig configuration you need to say 'load' in run-gln-ui.sh and MUST RE-ENABLE the filling! You can't say 'load' | ||
| while the system is filling. Sometimes you also need to exit and start the UI again before it allows you to execute 'load'. | while the system is filling. Sometimes you also need to exit and start the UI again before it allows you to execute 'load'. | ||
| Line 14: | Line 14: | ||
| * Run run-gln-ui.sh | * Run run-gln-ui.sh | ||
| * Say 'clr' to clear the alarm | * Say 'clr' to clear the alarm | ||
| - | * Check 'Fill Duration Plot' if this sensor got cold | + | * Check 'Fill Temperature Plot' if this sensor got cold |
| * If this happens regularly you may want to increase its trigger threshold in gln.fig (F1 directive, beginning in gln.fig) | * If this happens regularly you may want to increase its trigger threshold in gln.fig (F1 directive, beginning in gln.fig) | ||
| Line 32: | Line 32: | ||
| __Detector warm II__ | __Detector warm II__ | ||
| * What happened: Detector runs out of LN and really warms up | * What happened: Detector runs out of LN and really warms up | ||
| - | * IMPORTANT: detector T increased by few Kelvin only, see example plot below. | + | * IMPORTANT: detector T increased by few Kelvin only, see plot from **real-life example** (below). |
| * Run run-gln-ui.sh | * Run run-gln-ui.sh | ||
| * Say 'fill det#', confirm that you really want to fill it. | * Say 'fill det#', confirm that you really want to fill it. | ||
| Line 44: | Line 44: | ||
| - | Here an real-life example. After alarm got received you get following T-plot: | + | Here a **real-life example**. After alarm got received you get following T-plot: |
| {{:fillsystem:warm-up-example.pdf|}}. Actually after alarm you get it up to | {{:fillsystem:warm-up-example.pdf|}}. Actually after alarm you get it up to | ||
| channel ~1100 and see T is going up. Therefore it is a real alarm. Next you do | channel ~1100 and see T is going up. Therefore it is a real alarm. Next you do | ||
