Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
fillsystem:alarmresponse [2019/06/07 09:12] weisshaa |
fillsystem:alarmresponse [2019/06/07 09:14] weisshaa |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| __Detector warm II__ | __Detector warm II__ | ||
| * What happened: Detector runs out of LN and really warms up | * What happened: Detector runs out of LN and really warms up | ||
| - | * IMPORTANT: detector T increased by few Kelvin only, see example plot {{:fillsystem:warm-up-example.pdf|}}. | + | * IMPORTANT: detector T increased by few Kelvin only, see plot from **real-life example** (below). |
| * Run run-gln-ui.sh | * Run run-gln-ui.sh | ||
| * Say 'fill det#', confirm that you really want to fill it. | * Say 'fill det#', confirm that you really want to fill it. | ||
| Line 44: | Line 44: | ||
| - | Here an real-life example. After alarm got received you get following T-plot: | + | Here a **real-life example**. After alarm got received you get following T-plot: |
| {{:fillsystem:warm-up-example.pdf|}}. Actually after alarm you get it up to | {{:fillsystem:warm-up-example.pdf|}}. Actually after alarm you get it up to | ||
| channel ~1100 and see T is going up. Therefore it is a real alarm. Next you do | channel ~1100 and see T is going up. Therefore it is a real alarm. Next you do | ||
