This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
group_10 [2018/09/13 15:31] dombos |
group_10 [2018/09/14 09:19] (current) seymour |
||
---|---|---|---|
Line 93: | Line 93: | ||
**Problem 8** | **Problem 8** | ||
+ | |||
+ | As stated in Problem 7, the mass resolutions of '' | ||
+ | Mres_x = 60.123, and | ||
+ | Mres_y = 59.262. | ||
+ | |||
+ | We adjusted beam parameters until we saw Mres_x and Mres_y drop to around 55. | ||
+ | |||
+ | The beam position (offsetting the optical axis) can be changed with the '' | ||
+ | |||
+ | With '' | ||
+ | |||
+ | With '' | ||
+ | |||
+ | The beam size can be changed by adjusting the first and fourth parameter of the '' | ||
+ | |||
+ | With these two parameters each changed from the default 0.0015 to 0.0017, Mres_x and Mres_y each drop to about 55. A 0.2mm increase in size measurably drops the mass resolution. | ||
+ | |||
+ | Decreasing these parameters only increases the mass resolution. It seems the smaller the beam spot, the larger the mass resolution. | ||
+ | |||
+ | b) Adjusting the pitch, roll, yaw, x-position, and y-position of Q2 caused a drop in mass resolution at the mass slits (FP2), right after the Wien filter. | ||
+ | |||
+ | {{ : | ||
+ | {{ : | ||
+ | |||